Surprisingly, this project doesn't require any special code for the Raspberry Pi. This is where you might have to get creative, since no two monitors are the same. Monitor I used, so I drilled one hole on either side of the rear bezel that held the back cover on. Once you have a chosen layout, begin fastening the parts to the rear of the monitor.Īs for the picture-hanging wire, there were no decent places to connect on the Use this to figure out the best layout of all the parts to keep everything as slim as possible. Connect the Raspberry Pi to the HDMI port on the monitor and - without plugging in the extension cord - connect the power cables to both the Raspberry Pi and the monitor.
0 Comments
Leave a Reply. |